Installation; Preparations - Bosch VJT-X20XF-E Installation And Operating Manual

VideoJet XF E
4

Installation

4.1

Preparations

CAUTION!
The unit is intended for use indoors or in housings.
Select a suitable location for installation that guarantees to meet the environmental
conditions. The ambient temperature for the delivered power supply unit must be between
0 and +40 °C (+32 and +104 °F). The relative humidity must be between 20% and 80%. The
ambient temperature for the VideoJet XF E must be between 0 and +50 °C (+32 and +122 °F).
The relative humidity must not exceed 90%.
The VideoJet XF E generates heat during operation, so you should ensure that there is
adequate ventilation and enough clearance between the unit and heat-sensitive objects or
equipment. During installation, please note the maximum heat value of 31 BTU/h per unit
without the power supply.
Please ensure the following installation conditions:
–
–
–
–
–
–
–
Further topics:
–
Bosch Sicherheitssysteme GmbH
Do not install the unit close to heaters or other heat sources. Avoid locations exposed to
direct sunlight.
Allow sufficient space for running cables.
Ensure that the unit has adequate ventilation. Bear the total heat output in mind,
particularly when installing multiple units in a switch cabinet.
When making connections, use only the cables supplied or use appropriate cables
immune to electromagnetic interference.
Position and run all cables so that they are protected from damage, and provide
adequate cable strain relief where needed.
When installing in a switch cabinet, ensure that the screw joints are free of tension and
subject to as little mechanical stress as possible. Ensure that the unit and the power
supply units have sufficient grounding.
Avoid impacts, blows and severe vibrations that exceed the specification limits, as these
can irreparably damage the unit.
Section 9 Specifications, page 113
Installation and Operating Manual
Installation | en 15
DOC | V5.51 | 2012.03