VideoJet XF E
8.6
Network connection
You can display information about the network connection. To do this, move the cursor over
Link
UL
DL
8.7
Serial interface
Options for using the serial interface include transferring transparent data, controlling
connected units or operating the unit with a terminal program.
The serial interface supports the RS-232, RS-422 and RS-485 transmission standards. The
mode used depends on the current configuration. Connection is via the terminal block.
Further topics:
–
–
8.8
Terminal block
The terminal block has several contacts for:
–
–
–
Pin assignment serial interface
The pin assignment of the serial interface depends on the interface mode used.
Contact
CTS
TXD
RTS
RXD
GND
Further topics:
–
Pin assignment I/O
Contact
IN1
IN2
IN3
Bosch Sicherheitssysteme GmbH
Move the cursor over the graphic indicator. Some additional numerical values are also
displayed.
.
Ethernet link type
Uplink, speed of the outgoing data traffic
Downlink, speed of the incoming data traffic
Section 5.40 Advanced Mode: COM1, page 76
Section 8.8 Terminal block, page 109
4 alarm inputs
1 relay output
Serial data transmission
RS-232 mode
—
TxD (transmit data)
—
RxD (receive data)
GND (ground)
Section 5.40 Advanced Mode: COM1, page 76
Function
Input alarm 1
Input alarm 2
Input alarm 3
Installation and Operating Manual
RS-422 mode
RxD- (receive data minus)
TxD- (transmit data minus)
TxD+ (transmit data plus)
RxD+ (receive data plus)
—
Appendix | en 109
RS-485 mode
—
Data-
Data+
—
—
DOC | V5.51 | 2012.03