Connection; Sequence Of Connections; Connecting Monitors; Establishing The Network Connection - Bosch VIDEOJET decoder 7000 Installation Manual

VIDEOJET decoder 7000
5

Connection

5.1

Sequence of connections

Notice!
Do not connect the decoder to the power supply until all other connections have been made.
Otherwise the automatic assignment of the IP address will fail and a faulty monitor resolution
will be set. This may lead to serious damage of the unit.
5.2

Connecting monitors

You must connect a suitable monitor to the decoder. If mounting the unit to the back of a
monitor, use only monitors with standard VESA mount.
The unit provides one Mini DisplayPort and one HDMI port as monitor outputs. Both can be
used at the same time. Connect monitors using the respective monitor cable or adapter.
VGA connections are not supported.
5.3

Establishing the network connection

You must connect the decoder to a 10/100/1000 Base-T network using a standard UTP
category 5 cable with RJ45 plugs.
4
When the decoder is powered after finalizing all connections, the LEDs on the RJ45 socket
light up to indicate that the network connection has been set up correctly. Flashing green, the
left LED signals that data packages are being transmitted over the network.
5.4

Connecting audio

The decoder has no dedicated audio port. Audio is transmitted digitally via monitor output
HDMI.
5.5

Connecting the power supply

Power is supplied via a separate power supply unit that is part of the delivery. It offers 3
different power cords, one for use in the EU, one for China, and one for the USA.
Notice!
Use of improper power supply may lead to serious damage of the unit.
Use only the power supply unit that is included, together with the suitable power cord.
Connect the unit to an earthed mains socket-outlet.
Do not connect the decoder to the power supply until all other connections have been made.
1.
2.
The unit is now ready to use.
5.6

Power on/power off

The decoder is equipped with a power switch on its front panel.
The decoder automatically starts up when connected to mains power. The blue LED on the
front next to the switch lights up. During the boot process, the orange LED flashes.
4
After initial power-up you may use the power switch to turn the unit on or off.
Bosch Securtity Systems B.V.
Connect the unit to the network via the RJ45 socket.
Connect the decoder to the power supply unit.
Select the suitable power cord and plug this into the power supply unit and then into the
mains.
Switch on the monitor in order to see the user interface after the boot-up procedure.
Installation manual
Connection | en 13
2019.10 | v01 | F.01U.345.382