Advanced Mode: Com1 - Bosch VJT-X20XF-E Installation And Operating Manual

76 en | Configuration using a Web browser
5.40

Advanced Mode: COM1

You can configure the serial interface parameters (orange terminal block) to meet your
requirements.
If the VideoJet XF E is working in multicast mode, the first remote location to establish a video
connection to the unit is also assigned the transparent data connection. However, after about
15 seconds of inactivity the data connection is automatically terminated and another remote
location can exchange transparent data with the unit.
Serial port function
Select a controller or a protocol from the list matching the connected camera. If you wish to
use the serial port to transmit transparent data, select Transparent. Select Terminal if you
wish to operate the unit from a terminal.
NOTICE!
After selecting a controller or protocol, the remaining parameters in the window are set
automatically and should not be changed apart of the camera ID.
Camera ID
If necessary, enter the ID of the peripheral you wish to control (for example a dome camera or
pan/tilt). The entered ID relates to the peripheral that is connected to the first video input.
For further video inputs, the ID is automatically counted up. The connected peripheral devices
are addressed via the respective ID.
Baud rate
Select the value for the transmission rate in bps.
Data bits
The number of data bits per character cannot be changed.
Stop bits
Select the number of stop bits per character.
Parity check
Select the type of parity check.
Interface mode
Select the desired protocol for the serial interface.
DOC | V5.51 | 2012.03 Installation and Operating Manual
VideoJet XF E
Bosch Sicherheitssysteme GmbH