Connection; Sequence Of Connections; Connecting Monitors; Establishing The Network Connection - Bosch VJD-7000 Installation Manual

VIDEOJET decoder 7000
5

Connection

5.1

Sequence of connections

Notice!
Do not connect the decoder to the power supply until all other connections have been made.
Otherwise the automatic assignment of the IP address will fail and a faulty monitor resolution
will be set. This may lead to serious damage of the unit.
5.2

Connecting monitors

You must connect a suitable monitor to the decoder. You can obtain a list of approved
monitors from your supplier or directly from Bosch Security Systems. This list is constantly
being updated and extended.
The unit provides three monitor outputs, DVI-I, HDMI and DP; two of these can be used at the
same time.
Notice!
When connecting a monitor to the DVI-I output, do not use a DVI-to-VGA adapter.
The monitor must be equipped with a DVI input.
1.
2.
5.3

Establishing the network connection

You must connect the decoder to a 10/100/1000 Base-T network using a standard UTP
category 5 cable with RJ45 plugs.
4
When the decoder is powered after finalizing all connections, the LEDs on the RJ45 socket
light up to indicate that the network connection has been set up correctly. Flashing green, the
left LED signals that data packages are being transmitted over the network.
See also
–
5.4

Connecting audio

The decoder has an audio port for audio line signals (input and output, both mono).
The audio signals are transmitted two-way and in sync with the video signals. As a result, you
can connect a speaker, for example. The following specifications should be complied with in
all cases.
1 × Line In (blue ring):
1 × Line Out (green ring):
The stereo plug must be connected as follows:
Bosch Sicherheitssysteme GmbH
Decide for up to two monitor connections.
Connect each monitor using the respective monitor cable. When connecting to the DVI-I
monitor socket use a monitor cable with DVI-I plugs.
Connect the unit to the network via the RJ45 socket.
Power light and LEDs, page 19
Impedance 9 kohm typ., 5.5 V
Impedance 16 ohm min., 3 V
Installation Manual
Connection | en
max. input voltage
p-p
max. output voltage
p-p
2013.07 | V1 | DOC
15