Mounting - Bosch VJT-X20XF-E Installation And Operating Manual

16 en | Installation
4.2

Mounting

You can secure the VideoJet XF E to walls, below ceilings or any other load-bearing locations
using the wall-mounting panel, in either a vertical or a horizontal position.
CAUTION!
The mounting location must be able to reliably hold the unit. The load-bearing capacity must
be adequate for four times the weight of the unit.
If mounting the unit in a vertical position, you will need to use the lower plastic frame and
then place the unit onto the frame from above. If mounting the unit in a horizontal position,
you can use either of the two frames.
–
–
–
–
–
–
DOC | V5.51 | 2012.03
VI D
EO
IN 1
VI D
EO
IN 2
VI D
EO
IN 3
VI D
EO
IN 4
AU D
IO IN
AU D
IO O
UT
Lift the plastic frame on one side of the housing and carefully remove it from the unit.
Screw the plastic frame in the required position together with the wall-mounting panel.
Check that the plastic frame is secure.
Place the unit on the wall-mounting panel, with the panel positioned between the
housing and the second plastic frame.
Slide the unit into the plastic frame until you feel it lock securely into place.
Finally, check that the unit is securely attached in the installation location.
Installation and Operating Manual
VideoJet XF E
Bosch Sicherheitssysteme GmbH