Bosch VJT-X20XF-E Installation And Operating Manual page 78

78 en | Configuration using a Web browser
The settings on this page are used to integrate the VideoJet XF E into an existing network.
Some changes only take effect after the unit is rebooted. In this case, the Set button changes
to Set and Reboot.
1.
2.
CAUTION!
If you change the IP address, subnet mask, gateway address or the DHCP setting, the
VideoJet XF E is only available under the new addresses after the reboot.
Automatic IP assignment
If a DHCP server is employed in the network for the dynamic assignment of IP addresses, you
can activate acceptance of IP addresses automatically assigned to the VideoJet XF E.
Certain applications (Bosch Video Client, Bosch Video Management System) use the IP
address for the unique assignment of the unit. If you use these applications, the DHCP server
must support the fixed assignment between IP address and MAC address, and must be
appropriately set up so that, once an IP address is assigned, it is retained each time the
system is rebooted.
IP address
Enter the desired IP address for the VideoJet XF E in this field. The IP address must be valid
for the network.
Subnet mask
Enter the appropriate subnet mask for the selected IP address here.
Gateway address
If you want the unit to establish a connection to a remote location in a different subnet, enter
the IP address of the gateway here. Otherwise leave the box blank (0.0.0.0).
Prefix length
Enter the appropriate prefix length for the set IP address.
DNS server address
The unit can use a DNS server to resolve a mail or FTP server address specified as a name.
Enter the IP address of the DNS server here.
Video transmission
If the unit is operated behind a firewall, TCP (HTTP port) should be selected as the transfer
protocol. For use in a local network, select UDP.
CAUTION!
Multicast operation is only possible with the UDP protocol. The TCP protocol does not
support multicast connections.
HTTP browser port
Select a different HTTP browser port from the list if required. The default HTTP port is 80. If
you want to allow only secure connections via HTTPS, you must deactivate the HTTP port. In
this case, select Off.
HTTPS browser port
If you wish to allow browser access on the network via a secure connection, select an HTTPS
browser port from the list if necessary. The default HTTPS port is 443. Select the Off option
to deactivate HTTPS ports; only unsecured connections will now be possible.
DOC | V5.51 | 2012.03
Make the desired changes.
Click the Set and Reboot button. The VideoJet XF E is rebooted and the changed
settings are activated.
Installation and Operating Manual
VideoJet XF E
Bosch Sicherheitssysteme GmbH