Hardware Connections Between Video Servers - Bosch VJT-X20XF-E Installation And Operating Manual

VideoJet XF E
Bookmarks are only valid while you are in the RECORDINGS page; they are not saved with the
sequences. As soon as you leave the page all bookmarks are deleted.
Use the bookmarks as follows:
Check for updates
You can check for a newer version of the decoding software manually. After clicking the link a
new window is opened with instructions how to proceed.
6.7

Hardware connections between video servers

A VideoJet XF E with a camera connected to it can be used as a sender and a compatible
hardware decoder (such as the VIP XD HD) with a connected monitor as a receiver using an
Ethernet network connection. The sender and receiver must be located in the same subnet to
establish a hardware connection. In this way it is possible to cover long distances without the
need for major installation or cabling work.
CAUTION!
Hardware decoders VIP XD and VIP X1600 XFMD can only process algorithm H.264 BP+. Bear
this in mind when configuring profile settings.
Installation
Compatible video servers are designed to connect to one another automatically, provided
they are correctly configured. They only need to be part of a closed network. Proceed as
follows to install the units:
1.
2.
3.
Further topics:
–
Connecting
There are three options for establishing a connection between a sender and a compatible
receiver in a closed network:
–
–
–
NOTICE!
Connecting with a Web browser is described in the manual of the relevant unit that is to be
used as the receiver, for example VIP XD HD.
Bosch Sicherheitssysteme GmbH
Jump to the previous bookmark
Set bookmark
Jump to the following bookmark
Connect the units to the closed network using Ethernet cables.
Connect them to the power supply.
Make sure that the units are configured for the network environment and that the correct
IP address for the remote location to be contacted in the event of an alarm is set on the
Alarm Connections configuration page.
Section 5.30 Advanced Mode: Alarm Connections, page 60
an alarm,
a terminal program, or
Internet Explorer.
Installation and Operating Manual
Operation | en 101
DOC | V5.51 | 2012.03