Safety; Electric Shock Hazard; Installation And Operation; Maintenance And Repair - Bosch VIDEOJET 7000 Installation Manual

4 en | Safety
1

Safety

Read, follow, and retain for future reference all of the following safety instructions. Follow all
warnings before operating the device.
Warning!
Do not connect the decoder to the power supply until all other connections have been made.
!
Otherwise the automatic assignment of the IP address will fail and a faulty monitor resolution
will be set. This may lead to serious damage of the unit.
1.1

Electric shock hazard

–
–
–
–
–
–
–
–
1.2

Installation and operation

–
–
–
–
–
1.3

Maintenance and repair

–
–
–
2023-03 | V03 | F.01U.410.337
Never attempt to connect the unit to any power network other than the type for which it
is intended.
Use only the power supply unit that is included.
Connect the unit to an earthed mains socket-outlet.
Never open the housing.
Never open the housing of the power supply unit.
If a fault occurs, disconnect the power supply unit from the power supply and from all
other units.
Install the power supply and the unit only in a dry, weather-protected location.
If safe operation of the unit cannot be ensured, remove it from service and secure it to
prevent unauthorized operation. In such cases, have the unit checked by Bosch Security
Systems.
Safe operation is no longer possible if one or more of the following cases occur:
– The unit or power cables show visible damage.
– The unit operates incorrectly.
– The unit has been exposed to rain or moisture.
– Foreign bodies have penetrated the unit.
– The unit was stored under adverse conditions.
– The unit was exposed to extreme stress in transit.
The relevant electrical engineering regulations and guidelines must be complied with at
all times during installation.
Relevant knowledge of network technology is required to install the unit.
Pluggable devices must have an easily accessible socket-outlet installed near the
equipment.
Before installing or operating the unit, make sure you have read and understood the
relevant documentation. The documentation contains important safety instructions and
information about permitted uses.
Perform only the installation and operation steps described in this manual. Any other
actions may lead to personal injury, damage to property or damage to the equipment.
Never open the housing of the unit. The unit does not contain any user-serviceable parts.
Never open the housing of the power supply unit. The power supply unit does not contain
any user-serviceable parts.
Ensure that all maintenance or repair work is carried out only by qualified personnel
(electrical engineers or network technology specialists). In case of doubt, contact your
dealer's technical service center.
Installation manual
VIDEOJET decoder 7000
Bosch Securtity Systems B.V.