Table 5-27: Media Settings, Voice Settings Parameters - AudioCodes Mediant 1000 User Manual

H.323 User's Manual
Click the Submit button to save your changes.
3.
To save the changes so they are available after a power fail, refer to Section
4.
page 193.
Parameter
Voice Volume
[VoiceVolume]
Input Gain
[InputGain]
Silence Suppression
[EnableSilenceCompression]
Echo Canceler
[EnableEchoCanceller]
DTMF Transport Type
[DTMFTransportType]
MF Transport Type
[MFTransportType]
DTMF Volume (-31 to 0 dB)
[DTMFVolume]
Enable Answer Detector
[EnableAnswerDetector]
Answer Detector Activity Delay
[AnswerDetectorActivityDelay]
Answer Detector Silence Time
[AnswerDetectorSilenceTime]
Answer Detector Redirection
[AnswerDetectorRedirection]
Answer Detector Sensitivity
[AnswerDetectorSensitivity]
CAS Transport Type
[CASTransportType]
Version 5.0

Table 5-27: Media Settings, Voice Settings Parameters

Description
Voice gain control in dB. This parameter sets the level for the transmitted
(IP PSTN/Tel) signal.
The valid range is -32 to 31 dB.
The default value is 0 dB.
PCM input gain control in dB. This parameter sets the level for the received
(Tel/PSTN IP) signal.
The valid range is -32 to 31 dB.
The default value is 0 dB.
Note: This parameter is intended for advanced users. Changing it affects
other gateway functionalities.
Silence Suppression is a method conserving bandwidth on VoIP calls by not
sending packets when silence is detected.
Disable [0] = Silence Suppression disabled (default).
Enable [1] = Silence Suppression enabled.
Enable without adaptation [2] = A single silence packet is sent during silence
period (applicable only to G.729).
Note: If the selected coder is G.729, the following rules determine the value
of the 'annexb' parameter of the fmtp attribute in the SDP.
EnableSilenceCompression = 0
EnableSilenceCompression = 1
EnableSilenceCompression = 2 and IsCiscoSCEMode = 0
EnableSilenceCompression = 2 and IsCiscoSCEMode = 1
Off [0] = Echo Canceler disabled.
On [1] = Echo Canceler enabled (default).
DTMF Mute
remote.
Transparent DTMF
RFC 2833 Relay DTMF [3] = Erase digits from voice stream, relay to
remote according to RFC 2833 (default).
Note: This parameter is automatically updated if one of the following
parameters is configured: TxDTMFOption or RxDTMFOption.
N/A.
DTMF gain control value in dB (to the TDM side).
The valid range is -31 to 0 dB.The default value is -11 dB.
N/A.
N/A.
N/A.
N/A.
Determines the Answer Detector sensitivity.
The range is 0 (most sensitive) to 2 (least sensitive). The default is 0.
0 = Disable CAS relay (default).
1 = Enable CAS relay mode using RFC 2833.
The CAS relay mode can be used with the TDM tunneling feature to enable
tunneling over IP for both voice and CAS signaling bearers.
'annexb=no'.
'annexb=yes'.
[0] = Erase digits from voice stream, do not relay to
[2] = Digits remain in voice stream.
141
5. Web Management
5.9.2 on
'annexb=yes'.
'annexb=no'.
December 2006