AudioCodes Mediant 1000 User Manual page 229

H.323 User's Manual
Table 6-7: H.323 Configuration Parameters (continues on pages 226 to 232)
ini File Field Name
Web Parameter Name
H323IDString
SourceEncodeMode
DestEncodeMode
PortName_x
RegistrationTime
ResponseTimeOut
MaxRetries
RasSourcePort
RasDestPort
TimeBetweenGKsLoops
IsFallbackUsed
EnableH235Security
UserName
Password
IsFastConnectUsed
IsTunnelingUsed
EnableRAI
RAIHighThreshold
RAILowThreshold
RAILoopTime
TransparentCoderOnDataCall
Version 5.0
*
For a description of this parameter, refer to
For a description of this parameter, refer to
For a description of this parameter, refer to
This parameter is used to configure the H.323 Port ID table for assigning a
specific ID to each FXS or FXO port.
PortName_<Port> = <H.323 Port ID string>
For example:
PortName_0 = Port ID 1
Note 1: The numbering of channels starts with 0.
Note 2: This parameter can appear up to four times per each module.
For configuring the H.323 Port ID table using the Web interface, refer to
Section 5.5.7.1 on page 114.
For a description of this parameter, refer to
For a description of this parameter, refer to
For a description of this parameter, refer to
Defines a RAS source port from which the gateway sends RAS messages to
the Gatekeeper.
0 = Use dynamic port that is selected by the operating system.
1-65535 = Static port.
The default port is 1719.
Defines a RAS destination port to which the gateway sends RAS messages
to the Gatekeeper.
0 = Use dynamic port that is selected by the operating system.
1-65535 = Static port.
The default port is 1719.
For a description of this parameter, refer to
For a description of this parameter, refer to
For a description of this parameter, refer to
For a description of this parameter, refer to
For a description of this parameter, refer to
For a description of this parameter, refer to
For a description of this parameter, refer to
For a description of this parameter, refer to
For a description of this parameter, refer to
For a description of this parameter, refer to
For a description of this parameter, refer to
0 = Use only coders from the coder list (default).
1 = Use transparent coder for data calls.
Transparent coder can be used on data calls. When the gateway receives a
Setup message from the ISDN with TransferCapabilities = data, it can initiate
a Fast Start call using 'Transparent' coder (even if the coder is not included
in the coders list). This option is an AudioCodes' proprietary feature that
requires the use of Fast Start mode and the inclusion of the 'Transparent'
coder in the coder list of the receiving side.
6. ini File Configuration of the Mediant 1000
Valid Range and Description
229
Table 5-3 on page 64.
Table 5-3 on page 64.
Table 5-3 on page 64.
Table 5-4 on page 70.
Table 5-4 on page 70.
Table 5-4 on page 70.
Table 5-4 on page 70.
Table 5-4 on page 70.
Table 5-3 on page 64.
Table 5-3 on page 64.
Table 5-3 on page 64.
Table 5-3 on page 64.
Table 5-3 on page 64.
Table 5-4 on page 70.
Table 5-4 on page 70.
Table 5-4 on page 70.
Table 5-4 on page 70.
December 2006