Configuring The Snmp Community Strings; Figure 5-53: Snmp Community Strings Screen; Table 5-38: Snmp Community Strings Parameters - AudioCodes Mediant 1000 User Manual

5.6.8.2

Configuring the SNMP Community Strings

Use the SNMP Community Strings table to configure up to five read-only and up to five
read / write SNMP community strings, and to configure the community string that is used
for sending traps. For detailed information on SNMP community strings, refer to section
15.7.1 on page 354.
To configure the SNMP Community Strings, take these 5 steps:
Access the 'Management Settings' screen (Advanced Configuration menu >
1.
Management Settings); the 'Management Settings' screen is displayed
Open the 'SNMP Community Strings' screen by clicking the arrow sign (-->) to the
2.
right of the SNMP Community Strings label; the 'SNMP Community Strings' screen is
displayed
Configure the SNMP Community Strings parameters according to
3.
Click the Submit button to save your changes.
4.
To save the changes so they are available after a power fail, refer to Section
5.
page 193.
Note:
Parameter
Read Only Community String
[SNMPReadOnlyCommunityString_x]
Read / Write Community String
[SNMPReadWriteCommunityString_x]
Trap Community String
[SNMPTrapCommunityString]
H.323 User's Manual
(Figure 5-53).

Figure 5-53: SNMP Community Strings Screen

To delete a community string, select the Delete checkbox to the left of the
community string you want to delete, and then click the button Submit.

Table 5-38: SNMP Community Strings Parameters

Up to five read-only community strings (up to 19 characters each).
The default string is 'public'.
Up to five read / write community strings (up to 19 characters each).
The default string is 'private'.
Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
Description
174
Mediant 1000
(Figure 5-51).
Table 5-38.
5.9.2
Document #: LTRT-83401
on