AudioCodes Mediant 1000 User Manual page 94

Table 5-11: Number Manipulation Parameters (continues on pages 93 to 94)
Parameter
Prefix / Suffix to add
Number of digits to leave Enter the number of digits that you want to leave from the right.
Note: The manipulation rules are executed in the following order:
Num of stripped digits
Number of digits to leave
1.
Prefix / suffix to add
2.
Figure 5-14 on the previous page exemplifies the use of these manipulation rules in the 'Source Phone Number
Manipulation Table for Tel IP Calls':
When destination number equals 035000 and source number equals 20155, the source number is changed
to 97220155.
When source number equals 1001876, it is changed to 587623.
Source number 1234510012001 is changed to 20018.
Source number 3122 is changed to 2312.
NPI
TON
Presentation
H.323 User's Manual
Description
Prefix - Enter the number / string you want to add to the front of the phone
number. For example, if you enter 9 and the phone number is 1234, the new
number is 91234.
Suffix - Enter the number / string (in brackets) you want to add to the end of the
phone number. For example, if you enter (00) and the phone number is 1234, the
new number is 123400.
Note: You can enter a prefix and a suffix in the same field (e.g., 9(00)).
Select the H.225/Q.931 Number Plan assigned to this entry.
You can select Unknown [0], Private [9] or E.164 Public [1].
The default is Unknown.
For a detailed list of the available NPI/TON values, refer to Section
95.
Select the H.225/Q.931 Number Type assigned to this entry.
If you selected Unknown as the Number Plan, you can select Unknown [0].
If you selected Private as the Number Plan, you can select Unknown [0], Level 2
Regional [1], Level 1 Regional [2], PISN Specific [3] or Level 0 Regional (Local)
[4].
If you selected E.164 Public as the Number Plan, you can select Unknown [0],
International [1], National [2], Network Specific [3], Subscriber [4] or Abbreviated
[6].
The default is Unknown.
Select 'Allowed' to send Caller ID information when a call is made using these
destination / source prefixes.
Select 'Restricted' if you want to restrict Caller ID information for these prefixes.
When set to 'Not Configured', the privacy is determined according to the Caller ID
table (refer to Section 5.5.7.3 on page 116).
94
Mediant 1000
5.5.3.2 on page
Document #: LTRT-83401