Setting The Preferences; Figure C-3: Preferences Screen - AudioCodes Mediant 1000 User Manual

H.323 User's Manual
Use right-click on a line in the Log Window to open a pop-up window with the following
options:
Reset: Selecting this option results in a reset command being sent to the client VoIP
gateway. The program searches its database for the MAC address indicated in the
line. If the client is found in that database, the program adds the client MAC address to
the Address Resolution Protocol (ARP) table for the computer. The program then
sends a reset command to the client. This enables a reset to be sent without knowing
the current IP address of the client, as long as the computer sending the reset is on
the same subnet.
Note: In order to use reset as described above, the user must have administrator
privileges on the computer. Attempting to perform this type of reset without
administrator privileges on the computer results in an error message. ARP
Manipulation Enable must also be turned on in the Preferences window.
View Client: Selecting this option, or double clicking on the line in the log window,
opens the Client Configuration window. If the MAC address indicated on the line
exists in the client database, it is highlighted. If the address is not in the client
database, a new client is added with the MAC address filled out. You can enter data in
the remaining fields to create a new client entry for that client.
C.10 Setting the Preferences
The Preferences window (refer to
parameters.
Version 5.0
Figure

Figure C-3: Preferences Screen

385
C. BootP/TFTP Configuration Utility
C-3) is used to configure the BootP Tool
December 2006