AudioCodes Mediant 1000 User Manual page 143

H.323 User's Manual
Table 5-28: Media Settings, Fax/Modem/CID Parameters (continues on pages 142 to 144)
Parameter
Caller ID Type
[CallerIDType]
V.21 Modem Transport Type
[V21ModemTransportType]
V.22 Modem Transport Type
[V22ModemTransportType]
V.23 Modem Transport Type
[V23ModemTransportType]
V.32 Modem Transport Type
[V32ModemTransportType]
V.34 Modem Transport Type
[V34ModemTransportType]
Fax Relay Redundancy Depth
[FaxRelayRedundancyDepth]
Fax Relay Enhanced Redundancy
Depth
[FaxRelayEnhancedRedundanc
yDepth]
Version 5.0
Description
Defines one of the following standards for detection (FXO) and generation
(FXS) of Caller ID and detection (FXO) of MWI (when specified) signals.
Bellcore [0] (Caller ID and MWI) (default).
ETSI [1] (Caller ID and MWI)
NTT
[2]
British
[4]
DTMF ETSI
[16]
Denmark [17] (Caller ID and MWI)
India
[18]
Brazil
[19]
Note 1: The Caller ID signals are generated/detected between the first and
the second rings.
Note 2: To select the Bellcore Caller ID sub standard, use the parameter
'BellcoreCallerIDTypeOneSubStandard'. To select the ETSI Caller ID sub
standard, use the parameter 'ETSICallerIDTypeOneSubStandard'.
Note 3: To select the Bellcore MWI sub standard, use the parameter
'BellcoreVMWITypeOneStandard'. To select the ETSI MWI sub standard,
use the parameter 'ETSIVMWITypeOneStandard'.
V.21 Modem Transport Type that the gateway uses.
You can select:
0 = Disable (Transparent) -- default
1 = Enable Relay – N/A
2 = Enable Bypass
3 = Events Only (Transparent with Events)
V.22 Modem Transport Type that the gateway uses.
You can select:
0 = Disable (Transparent)
1 = Enable Relay -- N/A
2 = Enable Bypass -- default
3 = Events Only (Transparent with Events)
V.23 Modem Transport Type that the gateway uses.
You can select:
0 = Disable (Transparent)
1 = Enable Relay -- N/A
2 = Enable Bypass -- default
3 = Events Only (Transparent with Events)
V.32 Modem Transport Type that the gateway uses.
You can select:
0 = Disable (Transparent)
1 = Enable Relay -- N/A
2 = Enable Bypass -- default
3 = Events Only (Transparent with Events)
Note: This option applies to V.32 and V.32bis modems.
V.90 / V.34 Modem Transport Type that the gateway uses.
You can select:
0 = Disable (Transparent)
1 = Enable Relay -- N/A
2 = Enable Bypass -- default
3 = Events Only (Transparent with Events)
Number of times that each fax relay payload is retransmitted to the network.
The valid range is 0 to 2.
The default value is 0.
Number of times that control packets are retransmitted when using the T.38
standard.
The valid range is 0 to 4.
The default value is 2.
143
5. Web Management
December 2006