E.2.3
Initial Settings
To start the CPTWizard, take these 5 steps:
Execute the CPTWizard.exe file; the wizard's initial settings screen is displayed.
1.
Enter the IP address of the Mediant 1000/FXO module you are using.
2.
Select the gateway's ports that are connected to your PBX, and specify the phone
3.
number of each extension.
In the Invalid phone number field, enter a number that generates a 'fast busy' tone
4.
when dialed. Usually, any incorrect phone number should cause a 'fast busy' tone.
Click Next.
5.
Note:
H.323 User's Manual
Figure E-7: Initial Settings Screen
The CPTWizard communicates with the FXO module via TPNCP
(TrunkPack Network Control Protocol). If this protocol has been disabled in
the gateway configuration, the CPTWizard doesn't display the next screen
and an error is reported.
402
Mediant 1000
Document #: LTRT-83401