Dynacolor - Barco BARCOREALITY SIM 6 ULTRA R9040150 Owner's Manual

7.14 DynaColor™

What is done?
Due to the tolerance (lamps) and left-right setup (mirrors) of optical components, color differences may occur on the projected im-
age(s).
DynaColor™ allows a dynamic correction of these color differences, this is done by adding one primary color to another e.g. adding
Green to Red, the adjustment is possible on the left side, right side or both sides.
How to Start Up DynaColor?
1. Push the cursor key ↑ or ↓ to highlight DynaColor. (menu 7-39)
2. Press ENTER to select.
The DynaColor menu will be displayed. (menu 7-40)
SERVICE
UNIFORMITY
ELECTRONIC CONVERGENCE
DYNACOLOR
GRAY LEVEL DEFINITION
PURITY
DISPLAY BLANKING
PANEL ADJUSTMENT
PRESET INPUT BALANCE
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-39
How to Adjust DynaColor?
1. Push the cursor key ↑ or ↓ to highlight Adjust. (menu 7-41)
2. Press ENTER to select.
The DynaColor Info menu will be displayed. (menu 7-42)
3. Press ENTER to continue.
The DynaColor slider box will be displayed.
4. Use the COLOR key to select the desired Primary Color to adjust. (image 7-6)
5. Use the BALANCE key to select the left, right or both sides of the selected Primary Color. (image 7-7)
6. Use the TINT Key to select a Primary Color to add to the selection. (image 7-8)
7. Use the BRIGHTNESS key to adjust the level of adding the second Primary Color (Range: 0 to 1000). (image 7-9)
8. Press EXIT to return to the Primary Color Modulation menu.
DYNACOLOR
ADJUST
ACTIVE [OFF]
DEFAULT
INITIALIZE
Select with ↑ or ↓
<ENTER> to toggle/select
<EXIT> to return
Menu 7-41
R5976420 BARCOREALITY SIM 6 ULTRA 14052003
DYNACOLOR
ADJUST
ACTIVE [OFF]
DEFAULT
INITIALIZE
Select with ↑ or ↓
<ENTER> to toggle/select
<EXIT> to return
Menu 7-40
DYNACOLOR
<COLOR>
color to adjust
<TINT>
toggle between colors to add
<BRIGHTNESS>
adjust color
<BALANCE>
toggle between left, right
and both
<ENTER> to continue
<EXIT> to return
Menu 7-42
7. Service Mode
131