Operating The Projector; Switching On - Barco BARCOREALITY SIM 6 ULTRA R9040150 Owner's Manual

14 TEXT
15 ENTER
16 Cursor keys
17 EXIT
18 RC operation indication
Table 4-1

4.3 Operating the projector

4.3.1

Switching on

How to switch on.
1. Press the power switch to switch on the projector.
- When '0' is visible, the projector is switched off.
- When '1' is visible, the projector is switched on
The projector starts in standby mode. The projector indication lamp is red.
Starting image projection.
1. Press Stand by key once on the local keypad or on the remote control.
The projector mode indication lamp will be green (image 4-2, image 4-3)
Projector mode indication
Image 4-2
R5976420 BARCOREALITY SIM 6 ULTRA 14052003
when adjusting one of the image, e.g. controls during a meeting, the displayed bar scale
can be removed by pressing 'TEXT' key first. To re-display the bar scale on the screen,
press 'TEXT' key again.
to start up the adjustment mode or to confirm an adjustment or selection in the adjustment
mode.
to make menu selections when in the adjustment mode or to zoom/focus when the direct
access is active.
Comparison between the cursor keys and the use of the '+' and '-' keys on the local keypad
: RCU = local keypad
cursor key up = '+' key up
cursor key down = '-' key down
cursor key right = '+' key right
cursor key left = '-' key left
to leave the adjustment mode or to scroll upwards when in the adjustment mode.
lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
4. Getting started
25