Start Up; Identification; The Different Identification Screens - Barco BARCOREALITY SIM 6 ULTRA R9040150 Owner's Manual

7.3 Start up

How to start up the service mode ?
1. Push the cursor key ↑ or ↓ to highlight Service. (menu 7-1)
2. Press ENTER to select.
The Service Mode menu will be displayed. (menu 7-2)
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-1
Some items in the Service mode are password protected (when the password function is active). Enter the
password to continue. All other password protected items are now available if you stay in the adjustment
mode.

7.4 Identification

Overview
•

The different identification screens

• Displaying the identification screen
7.4.1 The different identification screens
What can be seen in the identification menu ?
• Title page: general information of the projector
• SIM Options: shows which options are installed
What can be seen on the title page screen?
The title page screen shows the general information of the projector.
The following items will be displayed:
• Type of projector: BARCOREALITY SIM6 ULTRA
• Proj. address: To change the address of the projector, see "Projector Address", page 30
• Software version
• Configuration:
- front/ceiling
- front/table
- rear/ceiling
- rear/table
• Baud rate PC: transfer speed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must
be the same as the baud rate of the connected computer. When there is a difference, consult 'Change Baudrate PC' in this
chapter.
• Text: Indicates if the on screen text information (picture setting textboxes: contrast,...) is enabled or not
• Projector Serial number: indicates the fabrication number of the projector. This number can be useful when calling for technical
assistance.
• Projector Run Time: gives the total run time since the first start up. All projectors leave the factory with a run time of approxi-
mately 24 hours.
What can be seen on the BARCOREALITY SIM6 ULTRA Options screen ?
Following options are indicated as active or inactive (ON/OFF)
R5976420 BARCOREALITY SIM 6 ULTRA 14052003
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ.ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTIME HISTORY
I2C DIAGNOSIS
DIMMING
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-2
SERVICE
UNIFORMITY
ELECTRONIC CONVERGENCE
DYNACOLOR
GRAY LEVEL DEFINITION
PURITY
DISPLAY BLANKING
PANEL ADJUSTMENT
PRESET INPUT BALANCE
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-3
7. Service Mode
119