Table of Contents
Advertisement
How to Initialize DynaColor?
1. Push the cursor key ↑ or ↓ to highlight Initialize. (menu 7-45)
2. Press ENTER to reset the DynaColor settings to 0.
3. Press EXIT to return to the Service Mode menu.
DYNACOLOR
ADJUST
ACTIVE [OFF]
DEFAULT
INITIALIZE
Select with ↑ or ↓
<ENTER> to toggle/select
<EXIT> to return
Menu 7-45
7.15 Gray Level Definition
What is done?
When switchers or other peripherals are used in the signal path from the source to the projector , signal level alterations may occur.
The Gray Level Definition allows to correct some off these alterations by adjusting the color levels of a selected Gray Level Range
(e.g. adjusting the Red level for the Gray Level Range: 1%-49%), 9 Gray Level Ranges are available.
Gray Level Definition only has an influence on external sources, not on the internal projector patterns.
How to Start Up Gray Level Definition?
1. Push the cursor key ↑ or ↓ to highlight Gray Level Definition. (menu 7-46)
2. Press ENTER to select.
The Gray Level Definition menu will be displayed. (menu 7-47)
SERVICE
UNIFORMITY
ELECTRONIC CONVERGENCE
DYNACOLOR
GRAY LEVEL DEFINITION
PURITY
DISPLAY BLANKING
PANEL ADJUSTMENT
PRESET INPUT BALANCE
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-46
How to Adjust Gray Level Definition?
1. Push the cursor key ↑ or ↓ to highlight Adjust. (menu 7-48)
2. Press ENTER to select.
The Gray Level Definition Info menu will be displayed. (menu 7-49)
3. Press ENTER to continue.
The Gray Level Definition menu will be displayed. (image 7-10)
4. Push the cursor key ← or → to highlight the Level % indication.
R5976420 BARCOREALITY SIM 6 ULTRA 14052003
GRAY LEVEL DEFINITION
ADJUST
ACTIVE [OFF]
INITIALIZE
Select with ↑ or ↓
<ENTER> to toggle/select
<EXIT> to return
Menu 7-47
7. Service Mode
133
Advertisement
Table of Contents
