Barco BARCOREALITY SIM 6 ULTRA R9040150 Owner's Manual page 88

5. Random Access
Image 5-41
Transport Delay basic principle
How to Start up the Transport Delay ?
1. Push the cursor key ↑ or ↓ to highlight Transport Delay in the Edit menu. (menu 5-95)
2. Press ENTER to select.
The Transport Delay menu will be displayed. (menu 5-96)
GUIDED GEOMETRY MAP
COARSE
LINEARITY
FINE
SHIFT
TRANSPORT DELAY
BLANKING/SOFT EDGE
RESET
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 5-95
In a set up with 1 projector skip the following adjustment procedure and always leave the Transport Delay in
the default automatic mode.
How to adjust the Transport Delay ?
The following procedure is described for a system with 3 projectors, apply the same guidelines for a multi-projector set up.
1. Make sure the 3 projectors are set to the default [AUTOMATIC] Transport Delay mode. (menu 5-97)
Each projector will automatically correct the Transport Delay to a certain value, e.g.:
Projector #
Projector 1
Projector 2
Projector 3
2. Leave the projector with the maximum value on [AUTOMATIC], in this case projector 2 with an Automatic Transport Delay of 250.
3. On Projector 1, push the cursor key to highlight Mode in the Transport Delay menu. (menu 5-98)
4. Press ENTER to toggle from [AUTOMATIC] to [MANUAL]. (menu 5-99)
5. Push the cursor key ↑ or ↓ to highlight Transport Delay. (menu 5-100)
6. Push the → cursor key to set the Transport Delay to the maximum value in the set up, in this case set the Transport Delay
manually to 250.
84
TRANSPORT DELAY
MODE [AUTOMATIC]
TRANSPORT DELAY = 168
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 5-96
Automatic Transport Delay
200
250
190
R5976420 BARCOREALITY SIM 6 ULTRA 14052003