Table of Contents
Advertisement
Max Lamp runtimes for the available projectors.
SIM Projector
BARCOREALITY SIM6 ULTRA
Using a lamp for more than its recommended life time is dangerous as the lamp could explode.
3.3 Switching to standby
How to switch to standby?
1. Press STANDBY for 2 seconds until the messages Saving data please wait is displayed. (image 3-3)
Saving data, please wait
Image 3-3
When switching to standby the projector waits for 30 sec. before it can be restarted. During this period the
LED display will show a jumping square with a dash. After one minute, two dashes will be displayed and the
projector can restart.
3.4 Switching off
How to switch off the projector?
To switch off the projector, handle as follow :
1. Press STANDBY key for 2 seconds. When the message Saving data, please wait is displayed, do not press any longer on the
STANDBY key otherwise the projector will restart.
When switching to standby the projector waits for 1 minute before it can restart again. During this period the LED display will
show a jumping square with a dash. After one minute, two dashes will be displayed and the projector can restart.
Warning: Let cool down the projector at least 10 min.
2. Switch off the projector with the power switch.
3.5 Source Specifications
BARCOREALITY SIM6 ULTRA Source Specifications
Critical source specifications:
•
Maximum Horizontal frequency of 115 kHz.
•
Maximum pixel frequency of 205 MHz.
R5976420 BARCOREALITY SIM 6 ULTRA 14052003
x (Max lamp runtime, in hours)
1000
3. Connections
15
Advertisement
Table of Contents
