Dynacolor™ (Optional) - Barco Reality SIM 6 Ultra II Owner's Manual

The Electronic Convergence slider box is displayed.
CONVERGENCE RED
Image 7-7
Electronic Convergence slider box
3. Push the cursor key ↑ or ↓ to select the desired color.
4. Push the cursor key ← or → to adjust the convergence (Range in pixels: –3 to +3)
5. Press EXIT to return to the Service Mode menu.
7.14 DynaColor™ (Optional)
What is done?
Due to the tolerance (lamps) and left-right setup (mirrors) of optical components, color differences may occur on the projected im-
age(s).
DynaColor™ allows a dynamic correction of these color differences, this is done by adding one primary color to another e.g. adding
Green to Red, the adjustment is possible on the left side, right side or both sides.
How to Start Up DynaColor?
1. Push the cursor key ↑ or ↓ to highlight DynaColor.
SERVICE
UNIFORMITY
ELECTRONIC CONVERGENCE
DYNACOLOR
GRAY LEVEL DEFINITION
PURITY
DISPLAY BLANKING
PANEL ADJUSTMENT
PRESET INPUT BALANCE
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-41
2. Press ENTER to select.
The DynaColor menu will be displayed.
DYNACOLOR
ADJUST
ACTIVE [OFF]
DEFAULT
INITIALIZE
Select with ↑ or ↓
<ENTER> to toggle/select
<EXIT> to return
Menu 7-42
How to Adjust DynaColor?
1. Push the cursor key ↑ or ↓ to highlight Adjust.
DYNACOLOR
ADJUST
ACTIVE [OFF]
DEFAULT
INITIALIZE
Select with ↑ or ↓
<ENTER> to toggle/select
<EXIT> to return
Menu 7-43
R5976707 REALITY SIM 6 ULTRA II 01/02/2005
0
7. Service Mode
197