Change Baudrate; Reset Lamp Runtime; Lamp Runtime History - Barco BARCOREALITY SIM 6 ULTRA R9040150 Owner's Manual

7.7 Change Baudrate

Start up
1. Push the cursor key ↑ or ↓ to highlight Change Baudrate PC. (menu 7-15)
2. Press ENTER to display the Change Baudrate PC menu. (menu 7-16)
The actual baudrate will be highlighted.
The following baud rates are available: 230400/115200/57600/38400/19200/9600/4800/1200
3. Push the cursor key ↑ or ↓ to highlight the desired baudrate.
4. Press ENTER to select.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ.ADDRESS
CHANGE BAUDRATE PC

RESET LAMP RUNTIME

LAMP RUNTIME HISTORY

I2C DIAGNOSIS
DIMMING
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-15
7.8 Reset Lamp Runtime
When is it allowed?
Reset lamp run time is only allowed when a new lamp is installed.
Start up
1. Push the cursor key ↑ or ↓ to highlight Reset Lamp Run Time. (menu 7-17)
2. Press ENTER.
The following warning will be displayed :
Risk of electrical shock. Reset lamp run time is reserved to qualified service personnel. If you are not qualified, press EXIT to
cancel the reset operation. (menu 7-18)
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ.ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTIME HISTORY
I2C DIAGNOSIS
DIMMING
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-17
7.9 Lamp Runtime history
What can be done?
Getting an overview of the different lamp run times
R5976420 BARCOREALITY SIM 6 ULTRA 14052003
CHANGE BAUDRATE PC
230400
115200
57600
38400
19200
9600
4800
1200
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-16
WARNING
---------------------
RISK OF
ELECTRICAL SHOCK
---------------------
RESET LAMP RUN TIME
is reserved to
qualified
service personnel
<ENTER> to accept
<EXIT> to return
Menu 7-18
7. Service Mode
123