Barco R9040171 Owner's Manual page 26

4. Getting started
Image 4-1
1 Function keys
2 MENU
3 Address key
4 LOGO key
5 PAUSE
6 STBY
7 MUTE
8
AUTOIMAGE
9 Digit buttons
9b SOURCE button
10 Lens control
11 VOL
12 Picture controls
13
DIGI ZOOM
22
user programmable keys with functions for direct access.
Menu key, to enter or exit the Toolbar menu.
(recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
allows to recall the stored Logo (not in PiP mode)
to stop projection for a short time, press 'PAUSE'. The image disappears but full power is
retained for immediate restarting.
standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to
go to standby, press the standby key for 2 seconds.
not used
Auto image, to center the image on the active LCD surface.
direct input selection.
this button allows to switch through the active (scanned) inputs
use these buttons to obtain the desired ZOOM, SHIFT, FOCUS.
not used
use these buttons to obtain the desired picture analog level.
allows a digital Zoom of a part of the image
R5976495 BARCOREALITY SIM 6 ULTRA MM 22102002