Blanking - Barco R9040171 Owner's Manual

How to enable the "Show native resolution" function?
1. Press MENU to activate the Toolbar
2. Press → to select the Image item
3. Press ↓ to Pull down the Image menu
4. Use ↑ or ↓ to select Show native resolution (image 7-4)
5. Press → to pull down the menu
6. Use ↓ or ↑ to select On
7. Press ENTER
A white bullet shows the selection
Image 7-4
The default mode is used if the show native resolution and the full screen function are off.
The default mode shows always the native ratio and forces the native resolution of the panels (part of the
image blanked where needed)

7.4 Blanking

What can be done ?
Blanking adjustments affect only the edges of the projected image and are used to frame the projected image on to the screen and
to hide or black out unwanted information (or noise). A '0' on the bar scale indicates no blanking.
Which blanking adjustments are available ?
• top blanking
• bottom blanking
• left blanking
• right blanking
How to blank ?
1. Press MENU to activate the Toolbar
2. Press → to select the Image item
3. Press ↓ to Pull down the Image menu
4. Use ↑ or ↓ to select Blanking (image 7-5)
5. Press → to pull down the menu
6. Use ↓ or ↑ to select left/right/up/down
7. Press ENTER
A white bullet shows the selection
R5976495 BARCOREALITY SIM 6 ULTRA MM 22102002
7. Image Menu
47