Table of Contents
Advertisement
14
FREEZ
15
PIP
16
ENTER
17
Cursor keys
18
BACK
20
PIP ADJUST
21
RC operating indication
22
IR receiver
Table 4-1
4.3 Switching on
How to switch on.
1. Press the power switch to switch on the projector.
The projector starts in standby mode. The projector indication lamp is red and the display indicates ( _ )
When switching back to standby, this will be indicated by ( -- ) on the display.
Starting image projection.
1. Press Stand by key once on the local keypad or on the remote control.
The projector mode indication lamp will be green
During the power on sequence the display shows (L). After that sequence the selected source is displayed ( when no source is
selected, the displays shows a point mark ). (image 4-2, image 4-3)
Image 4-2
R5976495 BARCOREALITY SIM 6 ULTRA MM 22102002
press to freeze the projected image.
allows to activate the PICTURE IN PICTURE mode
to confirm an adjustment or selection in the MENU.
On the local keypad the ENTER button additionally accesses the PIP window resize function
Cursor Keys on RCU or on the local keypad : to make menu selections or to access the
toolbar.
to leave the selected menu or item (go upwards to previous menu).
allows to select a PiP window and change its configuration on screen
lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
IR receiver
4. Getting started
23
Advertisement
Table of Contents
