Table of Contents
Advertisement
4. Getting started
Hardwired Remote Input
1. Plug one end of the remote cable in the connector on the bottom of the RCU.
2. Plug the other end in the connector in the front panel of the projector labelled RC. (image 4-5)
Image 4-5
Directly to one of the IR sensors of the projector.
When using the wireless remote control, make sure you are within the effective operating distance (30m, 100ft in a straight line). The
remote control unit will not function properly if strong light strikes the sensor window or if there are obstacles between the remote
control unit and the projector IR sensor.
Image 4-6
4.5.3
Projector address
Overview
•
Address setting
•
Displaying and Programming addresses into the RCU
26
R5976495 BARCOREALITY SIM 6 ULTRA MM 22102002
Advertisement
Table of Contents
