NTI PRIMUX MATRIX KVM SWITCH VIA CAT 5
Connecting the CAT5 cable to the Host Adapter
Connect CAT5 cable to the "OUT" port on the Host Adapter (Figure 6). When properly inserted, the cable end should snap into
place.
NOTE: If an RJ45 wall outlet is being used, connect the other end of the
extension cable to the RJ45 wall outlet.
!
WARNING: Never connect the PRIMUX Host Adapter to an Ethernet
card, Ethernet router, hub or switch or other Ethernet RJ45 connector of an
Ethernet device. Damage to devices connected to the Ethernet may result.
NOTE: The installer must ensure that all CAT5 cable between the Host Adapter
and the Switch is of the straight-through type and not crossed.
NOTE: HA-SUN-MTX Host Adapters require the insertion of a Terminating Plug (included) into the "IN" port on the Host
Adapter. Be sure to insert this plug.
Figure 7- Add terminating plug to HA-SUN-MTX Host Adapter
Cable to CPU
(Rear View)
Terminating
Plug (Supplied)
CAT5 Cable
to PRIMUX Switch
9
CAT5 Cable
to Matrix Switch
Figure 6- Connect CAT5 cable to Host Adapter
Cable to CPU
(Rear View)