NTI PRIMUX MATRIX KVM SWITCH VIA CAT 5
NTI
R
Network Technologies Inc
PRIMUX
TM
UZR
Keypad Control
The keypad on the front panel of the PRIMUX User Station enables a user to quickly set the User Station to connect to the desired
CPU.
Two seven-segment LEDs illuminate to show the index number of the Host Adapter the user is connected to. The Up and
Down buttons enable the user to search for the desired CPU. The Favorite buttons, 1-8, can be programmed for quick selection
of the most commonly connected CPUs. (See Figure 18)
To program a Favorite button,
-
Use the Search buttons to select the desired Host Adapter index number to connect with (or use OSD Command
Mode).
-
With the index number in the LED display, press and hold the Favorite button to be associated with it for at least 2
seconds. The LED will blink when the selection is remembered and until the Favorite button is released.
-
When this button is pressed and released, the User Station will immediately connect to the selected Host
Adapter.
-
Repeat for each Favorite button to be programmed.
Note: Favorite buttons are not available when PRIMUX is mounted in a RACKMUX-15/17-PRIMUX drawer. See "Favorite
Hosts" on page 26 to use Favorites through the OSD menu.
Up
1
Search
CPU
Down
Figure 18- PRIMUX-UZR front panel
Favorites
2
3
4
5
6
7
19
8