NTI PRIMUX MATRIX KVM SWITCH VIA CAT 5
Update Host Adapter Firmware
To use the "Update Host Adapters" command, the image downloaded using the bootloader (previous page) must be for either a
HA_UNV, HA_SUN, or HA_RS. The type of image downloaded into the bootloader will be shown.
Adapter, the word "INVALID" will be shown.
When updating a Host Adapter, the downloaded image must match the type of Host Adapter selected:
Host Adapter Type
Downloaded Image needed (firmware file)
UNV
PRIMUX_HA_UNV_x_x.b01 (where x_x is the version)
SUN
PRIMUX_HA_SUN_x_x.b01
SER (RS)
PRIMUX_HA_RS_x_x.b01
-
Press <P> from the Firmware Configuration menu.
-
Press the <Up arrow> or <Down arrow> to select the Host Adapter to be upgraded (or press <F> to use the
"Find" Feature to assist locating the desired Host Adapter).
-
Press <Spacebar> to toggle the radio button to lock in the selection. Make sure the Host Adapter selected matches the
type of image downloaded.
-
Press <U> for "Update Host" to send the firmware to the selected Host Adapter. An indication of percentage of transfer
will appear. At 100% the update will be complete. If the Host Adapter selected is not powered, inaccessible, or just not
functioning properly, an error will be displayed.
Select Keyboard Language
To enter the Select Keyboard Language menu press <K> from the User Station Configuration menu (from Command Mode press
<A> - <R> - <K>).
Figure 40- Update Host Adapters
The Host Adapter List will appear.
Figure 41- Select Keyboard Language menu
39
If the image is not for a Host