Table of Contents
Advertisement
NTI SERIMUX SERIES CONSOLE SWITCH
INITIAL STARTUP
SERIMUX Quick Start
The following instruction will enable the user to quickly make port connections using a terminal connected to the
"CONSOLE" port. For instruction to make quick connection using the optional Ethernet port and Web Interface, see
page 35.
1.
Make sure the SERIMUX is turned OFF.
2.
Using the serial device connected to the port labeled "CONSOLE", start the terminal program (e.g. Windows HyperTerminal)
and configure it as follows:
•
direct connection (using the appropriate CPU local serial Com port)
•
9600 bps
•
8 bits
•
no parity
•
1 stop bit
•
no flow control
•
ANSI or VT100 terminal mode.
Within the SERIMUX firmware, the "CONSOLE" port is identified as Port 0.
mentioned within this manual, it refers to the terminal connected at "CONSOLE".
3.
Power ON the SERIMUX. Wait 2 seconds.
4.
Press [ Enter ] on the keyboard and wait 3 seconds to be recognized as the default SERIMUX user. The "Accessible host list"
for "User01", logged in at "Port00" will be displayed (see Fig. 6). By default, all ports are configured as Host ports and all are
accessible.
NOTE: If the user menu does not display reset the SERIMUX following the "Reset SERIMUX Console Switch to default
settings" instructions on page 34.
5.
To connect to an attached CPU, enter the number of the port the CPU is connected to and press [Enter].
Figure 6- Startup- Accessible host list
8
For consistency, when Port 0 is
Advertisement
Table of Contents
