Installation Of A Serial-Controlled Server Or Device; Figure 4- Connect An Ha-Rs-M Host Adapter To A Server; Figure 5- Connect An Ha-Rs-M Host Adapter To A Dce Type Device - Network Technologies PRIMUX-16X64 Installation And Operation Manual

NTI PRIMUX MATRIX KVM SWITCH VIA CAT 5

Installation of a Serial-Controlled Server or Device

Plug the cables of the HA-RS-M Host Adapter into the serial port on a server (DTE) or other serially-controlled data terminal
equipment (DTE) device. If the device is a data communication equipment (DCE) type device, a crossover adapter
(NTI RJ45MF-RS232-CO- sold separately) will be required.
a) Connect the RJ45 cable end to the serial control port on the serial device. A DB9-to-RJ45 console adapter (supplied
with the HA-RS-M) may be required to make this connection.
b) Connect the USB Type A cable to any available USB Type A female port. If the device being controlled does not
have a USB port, connect it to any USB Type A port on a device nearby. Any USB Type A port will do, as the
HA-RS-M is only using the power supplied by two of the four terminals in the connector.
DB9F-RJ45F
Console Adapter
(Supplied with HA-RS-M)
SERIAL-CONTROLLED SERVER
(DTE)
CONNECT TO ANY AVAILABLE USB PORT
(HA-RS-M USES POWER TERMINALS ONY)
NTI SERIMUX/ IPDU-S2/ (ETC.)
(DCE DEVICE)
SERIAL CROSSOVER ADAPTER
Pinout for RJ45 Female to RJ45 Male crossover Adapter
RJ45-F
Pin Signal
1 CTS Connected to
2 DSR Connected to
3 RxD Connected to
4 GND Connected to
5 DCD Connected to
6 TxD Connected to
7 DTR Connected to
8 RTS Connected to
Note: The serial port on the device must be configured for a maximum baud rate of 115200 bps.
USB Type A male

Figure 4- Connect an HA-RS-M Host Adapter to a server

USB Type A male
RJ45MF-RS232-CO
(sold separately)

Figure 5- Connect an HA-RS-M Host Adapter to a DCE type device

RJ45-M
Pin Signal
8 RTS
7 DTR
6 TxD
4 GND
1 CTS
3 RxD
N/c
2 DSR
RJ45 Male
8
(Front View)
(Front View)