NTI PRIMUX MATRIX KVM SWITCH VIA CAT 5
INSTALLATION
Install The Host Adapter
The PRIMUX HA Host Adapter is designed to support PS/2, SUN and USB CPUs, in addition to serial devices with an RS232
port. For PS/2 or USB CPUs use HA-UNV, for SUN CPUs use HA-SUN-MTX, and for serially-controlled servers or devices use
HA-RS-M. Before installing or removing a Host Adapter, power down the CPU to be connected/disconnected and disconnect the
power cord from the CPU.
CAUTION!
D
AMAGE MAY OCCUR TO THE
CONNECTING OR DISCONNECTING CABLES
Installation of a HA-UNV to a PS/2 CPU
Plug the cables of the HA-UNV Host Adapter into the back of the PS/2 CPU after disconnecting the power cord from the CPU.
(See Figure 1.)
a)
Connect the green 6 pin miniDIN to USB adapter (provided) to the USB cable
end and plug it into the mouse port on the back of the CPU.
b)
Connect the purple 6 pin miniDIN cable end with the keyboard symbol
on it to the keyboard port on the back of the CPU.
c)
Connect the blue 15HD cable end to the VGA port on the back of the CPU.
male connectors
6 pin miniDIN
female connectors
15HD female
video connector
Rear View of PS/2 CPU
CPU
AND
.
6 miniDIN
USB-PS/2 Adapter
Figure 1- Connect a HA-UNV Host Adapter to a PS/2 CPU
H
A
OST
DAPTER IF POWER IS NOT DISCONNECTED BEFORE
PS/2 keyboard (purple)
(mouse)
15HD male
video connector
6
PS/2 Keyboard
(Front View)
Note: When hotplugging the
mouse and keyboard cables into
a PS/2 CPU, be sure to connect
the mouse cable first, then the
keyboard cable. Failure to
connect in this order may cause
the mouse to not be recognized
by the CPU.