NTI PRIMUX MATRIX KVM SWITCH VIA CAT 5
Installation of a HA-UNV to a USB CPU
Plug the cables of the HA-UNV Host Adapter into the back of the USB CPU after disconnecting the power cord from the CPU.
(See Figure 2.)
a)
Connect the cable with the USB Type A male cable end on it to a USB Type A female port on the back of the
CPU.
b)
Connect the blue 15HD cable end to the video connector on the back of the CPU.
NOTE: The purple keyboard connector cannot be used when the HA-UNV is installed on a USB CPU. In this installation,
the USB connector will carry both the mouse and keyboard communication signals to the CPU.
USB Type A
device port
15HD female
video connector
Installation of a Legacy SUN CPU
Plug the cables of the HA-SUN-MTX Host Adapter into the back of the CPU after disconnecting the power cord from the CPU.
(See Figure 3.)
a)
Connect the orange 8 pin miniDIN cable end on it to the devices port on the back of the CPU.
b)
Connect the blue 15HD cable end to the VGA port on the back of the CPU.
Rear View of SUN CPU
8 pin miniDIN
female connector
Figure 3- Connect a HA-SUN-MTX Host Adapter to a Legacy SUN CPU
PS/2 Keyboard Connector cannot be used
when the USB connector is plugged directly
into the USB CPU.
USB Type A male
Rear View of USB CPU
Figure 2- Connect a HA-UNV Host Adapter to a USB CPU
15HD female
video connector
15HD male
video connector
orange-devices
7
(Front View)
(Front View)
FYI: The HA-SUN-MTX Host
Adapter does not provide
keyboard power-ON support
for legacy SUN CPUs.