Table of Contents
Advertisement
NTI PRIMUX MATRIX KVM SWITCH VIA CAT 5
Firmware Configuration
New improved versions of firmware may become available for the PRIMUX Matrix KVM Switch. The Firmware Configuration
menu is provided to enable the user to initiate a firmware update. Select "Firmware Configuration" in the Main Menu and press
<Enter> to open the Firmware Configuration submenu.
Figure 54- Telnet- Firmware Configuration
The Firmware Configuration submenu shows the present PRIMUX Matrix firmware code revision number and the date that code
was created. From this menu the user can force the PRIMUX Matrix to reboot which will cause any users to be logged out of the
system. Users must wait for the PRIMUX Matrix to finish rebooting before logging back into the system.
To update the Firmware in the PRIMUX Matrix, refer to page 56 .
Network Configuration
The Network Configuration menu enables the user to make adjustments to the network settings as needed. Select "Network
Configuration" in the Main Menu and press <Enter> to open the Network Configuration submenu.
Figure 55- Telnet- Network Configuration
The IP address mode is set to "Static" by default (user specified IP address, gateway, etc.), but may be set to "DHCP" (settings
will be automatically assigned by a network accessible DHCP server).
If the mode is set to "Static", enter suitable settings for the IP address (default is 192.168.1.22), subnet mask, etc...
The Telnet Server must be set to "Enabled" in order to access the PRIMUX Matrix menu over the Ethernet. By default it is
disabled.
Press <Esc> to return to the previous menu and apply the changes made.
Note: Changes made may disconnect your session.
50
Advertisement
Table of Contents
