D-Link xStack DGS-3120 Series Reference Manual page 437

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
MIP
SenderID
CCM
MEP ID(s)
Click the Apply button to accept the changes made.
After clicking the MIP Port Table button, the following window will appear:
Click the <<Back button to return to the previous page.
Figure 10-3 CFM MA Settings - Edit Window
Description
This is the control creation of MIPs.
None - Don't create MIPs.
Auto - MIPs can always be created on any ports in this MA, if that port is not configured
with a MEP of that MA.
Explicit - MIP can be created on any ports in this MA, only if the next existent lower
level has a MEP configured on that port, and that port is not configured with a MEP of
this MA.
Defer - Inherit the setting configured for the maintenance domain that this MA is
associated with. This is the default value.
This is the control transmission of the sender ID TLV.
None - Don't transmit sender ID TLV.
Chassis - Transmit sender ID TLV with chassis ID information.
Manage - Transmit sender ID TLV with manage address information.
Chassis Manage - Transmit sender ID TLV with chassis ID information and manage
address information.
Defer - Inherit the setting configured for the maintenance domain that this MA is
associated with. This is the default value.
This is the CCM interval.
100ms - 100 milliseconds. Not recommended. For test purpose.
1sec - One second.
10sec - Ten seconds. This is the default value.
1min - One minute.
10min - Ten minutes.
This is to specify the MEP IDs contained in the maintenance association. The range of
the MEP ID is 1-8191.
Add - Add MEP ID(s).
Delete - Delete MEP ID(s).
By default, there is no MEP ID in a newly created maintenance association.
Figure 10-4 CFM MIP Port Table Window
427