D-Link xStack DGS-3120 Series Reference Manual page 151

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
State
Replace Source IP
Remap Priority
Replace Priority
CVID (1-4094)
Unit
Untagged Member Ports
Tagged Member Ports
Untagged Source Ports
Tagged Source Ports
Click the Select All button to select all the ports for configuration.
Click the Clear All button to unselect all the ports for configuration.
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
After clicking the Profile List
The fields that can be configured are described below:
Parameter
Profile Name
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specific entry.
Click the Show MLD Snooping Multicast VLAN Entries
Description
Use the drop-down menu to enable or disable the state.
With the MLD snooping function, the MLD report packet sent by the host will be
forwarded to the source port. Before forwarding of the packet, the source IP
address in the join packet needs to be replaced by this IP address. If Not
Replaced is specified, the source IP address will not be replaced.
0-7 – The remap priority value (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
None – Specify to use the packet's original priority. The default setting is None.
Tick the check box to specify that the packet's priority will be changed by the
switch, based on the remap priority. This flag will only take effect when the remap
priority is set.
Deselect the Null check box and enter the customer VALN ID carrying in MLD
query when Q-in-Q function is enabled.
Select the unit you want to configure. (EI and SI Mode Only)
Specify the untagged member port of the multicast VLAN.
Specify the tagged member port of the multicast VLAN.
Specify the source port or range of source ports as untagged members of the
multicast VLAN. The PVID of the untagged source port is automatically changed
to the multicast VLAN. Source ports must be either tagged or untagged for any
single multicast VLAN, i.e. both types cannot be members of the same multicast
VLAN.
Specify the source port or range of source ports as tagged members of the
multicast VLAN.
link, the following window will appear:
Figure 4-97 MLD Snooping Multicast VLAN Group List Settings window
Description
Use the drop-down menu to select the IGMP Snooping Multicast VLAN Group Profile
name.
link to view the MLD Snooping Multicast VLAN Settings.
141