D-Link xStack DGS-3120 Series Reference Manual page 299

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Profile ID (1-5)
Select ACL Type
Source MAC Mask
Destination MAC
Mask
802.1Q VLAN
802.1p
Ethernet Type
Click the Select button to select a CPU ACL type.
Click the Create button to create a profile.
Click the <<Back button to discard the changes made and return to the previous page.
Figure 7-24 Add CPU ACL Profile (Ethernet ACL)
Description
Enter a unique identifier number for this profile set. This value can be set from 1 to 5.
A lower value denotes a higher priority.
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or
packet content mask. This will change the window according to the requirements for
the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
Select IPv4 to instruct the Switch to examine the IP address in each frame's header.
Select IPv6 to instruct the Switch to examine the IP address in each frame's header.
Select Packet Content Mask to specify a mask to hide the content of the packet
header.
Enter a MAC address mask for the source MAC address.
Enter a MAC address mask for the destination MAC address.
Selecting this option instructs the Switch to examine the VLAN identifier of each
packet header and use this as the full or partial criterion for forwarding.
Selecting this option instructs the Switch to specify that the access profile will apply
only to packets with this 802.1p priority value.
Selecting this option instructs the Switch to examine the Ethernet type value in each
frame's header.
289