Command Logging Settings - D-Link xStack DGS-3120 Series Reference Manual

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
Management
Configuration
Network Monitoring
Community Strings and Trap
Stations
Update Firmware and
Configuration Files
System Utilities
Factory Reset
User Account Management
Add/Update/Delete User Accounts
View User Accounts
The fields that can be configured are described below:
Parameter
User Name
Password
Confirm Password
Access Right
Encryption
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
NOTICE: In case of lost passwords or password corruption, please refer to the appendix chapter
entitled, "Password Recovery Procedure," which will guide you through the steps necessary
to resolve this issue.
NOTE: The username and password should be less than 16 characters.

Command Logging Settings

This window is used to enable or disable the command logging settings.
To view this window, click System Configuration > Command Logging Settings, as shown below:
The fields that can be configured are described below:
Admin
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Read/Write
Description
Enter a new user name for the Switch.
Enter a new password for the Switch.
Re-type in a new password for the Switch.
Specify the access right for this user.
Specify that encryption will be applied to this account. Option to choose from are Plain
Text, and SHA-1.
Figure 2-33 Command Logging Settings window
Operator Power User
Read/Write– Read/Write–
partly partly
Read/Write Read-only
Read-only Read-only
Read/Write No
Read-only Read-only
No No
No No
No No
32
User
No
Read-only
Read-only
No
Read-only
No
No
No