Multicast Filtering Mode - D-Link xStack DGS-3120 Series Reference Manual

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
Profile ID / Profile
Name
Click the Apply button to accept the changes made.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specific entry.
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IPv6 Max Multicast Group Settings
Users can configure the ports and VLANs on the switch that will be a part of the maximum filter group, up to a
maximum of 1024.
To view the following window, click L2 Features > Multicast Filtering > IPv6 Multicast Filtering > IPv6 Max
Multicast Group Settings, as shown below:
The fields that can be configured are described below:
Parameter
Ports / VID List
Max Group
Action
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

Multicast Filtering Mode

Users can configure the multicast filtering mode.
To view the following window, click L2 Features > Multicast Filtering > Multicast Filtering Mode, as shown
below:
Use the drop-down menu to select the profile ID or profile name used and then assign
Permit or Deny access to them.
Figure 4-105 IPv4 Max Multicast Group Settings window
Description
Select the appropriate port(s) or VLAN IDs used for the configuration here.
If the checkbox Infinite is not selected, the user can enter a Max Group value.Tick
the Infinite check box to enable the use of the Infinite value.
Use the drop-down menu to select the appropriate action for this rule. The user can
select Drop to initiate the drop action or the user can select Replace to initiate the
replace action.
146