D-Link xStack DGS-3120 Series Reference Manual page 248

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
Last Hop SPT
Switchover
Register Checksum
Calculate
Embedded RP State
Click the Apply button to accept the changes made.
PIM for IPv6 Interface Settings
This window is used to configure the settings for the PIM for IPv6 protocol per IP interface.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for
IPv6 Interface Settings, as shown below:
Click the Edit button to re-configure the specific entry.
Click the Edit button to see the following window.
The fields that can be configured are described below:
Use the drop-down menu to select the SPT switchover mode on the last-hop switch.
Never - The mode will never switch to SPT. This is the default value.
Immediately - The mode will immediately switch to SPT.
Use the drop-down menu to select the register packet checksum calculating
mechanism.
Not Include Data - When calculate the checksum in IPv6 PIM register packet, the
data portion won't be included.
Include Data - When calculate the checksum in IPv6 PIM register packet, the data
portion will be included.
Use the drop-down menu to enable or disable the embedded RP support in the PIM
for IPv6 state.
Figure 5-119 PIM for IPv6 Interface Settings window
Figure 5-120 PIM for IPv6 Interface Settings – Edit window
238