D-Link xStack DGS-3120 Series Reference Manual page 379

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
To view this window, click Security > BPDU Attack Protection as shown below:
The fields that can be configured are described below:
Parameter
BPDU Attack
Protection State
Trap State
Log State
Recover Time (60-
1000000)
Unit
From Port / To Port
State
Mode
Click the Apply button to accept the changes made for each individual section.
Figure 8-63 BPDU Attack Protection window
Description
Click the radio buttons to enable or disable the BPDU Attack Protection state.
Specify when a trap will be sent. Options to choose from are None, Attack
Detected, Attack Cleared or Both.
Specify when a log entry will be sent. Options to choose from are None, Attack
Detected, Attack Cleared or Both.
Specify the BPDU protection Auto-Recovery timer. The default value of the recovery
timer is 60. Tick the Infinite check box so that the port will not recovered
automatically.
Select the unit you want to configure. (EI and SI Mode Only)
Select a range of ports to use for this configuration.
Use the drop-down menu to enable or disable the protection mode for a specific
port.
Specify the BPDU protection mode. The default mode is shutdown.
Drop – Drop all received BPDU packets when the port enters under attack state.
Block – Drop all packets (include BPDU and normal packets) when the port enters
under attack state.
Shutdown – Shut down the port when the port enters under attack state.
369