Table of Contents
Advertisement
The following illustrations show the locations of the power-supply LEDs for fixed
and redundant models respectively on the rear of the server.
v PCI riser slot 1: Insert a full-height, half-length PCI Express adapter into this
slot. See "Installing an adapter" on page 46 for the supported adapters for these
riser-cards.
v PCI riser slot 2: Insert a low-profile PCI Express adapter into this slot. See
"Installing an adapter" on page 46 for information about adapters that this riser
card support.
v Power connector: Connect the power cord to this connector.
v AC power LED: Each power supply has an ac power LED and a dc power LED.
When the ac power LED is lit, it indicates that sufficient power is being supplied
to the power supply through the power cord. During normal operation, both the
ac and dc power LEDs are lit. For any other combination of LEDs, see
"Power-supply LEDs" on page 114.
v DC power LED: Each power supply has a dc power LED and an ac power LED.
When the dc power LED is lit, it indicates that the power supply is supplying
adequate dc power to the system. During normal operation, both the ac and dc
power LEDs are lit. For any other combination of LEDs, see "Power-supply
LEDs" on page 114.
Chapter 1. The IBM System x3530 M4 Type 7160 server
19
Advertisement
Table of Contents
Troubleshooting
