Replacing The Simple-Swap Sata Drive Backplate Assembly - IBM System x3530 M4 Installation And Service Manual

7. If you are instructed to return the backplate assembly, follow all packaging

Replacing the simple-swap SATA drive backplate assembly

To install the replacement simple-swap SATA drive and backplate assembly,
complete the following steps:
Note: The simple-swap SATA drive and backplate assembly must be installed in
the backplane slot closest to the information panel and the SATA drive must be
installed in the drive-bay closest to the information panel. The backplate assembly
cable connects to the CD/DVD-ROM drive connector on the system board.
1. Read the safety information that begins on page Safety and "Installation
2. Align the tabs on the bottom of the drive backplate with the backplate slots on
346
System x3530 M4 Type 7160: Installation and Service Guide
instructions, and use any packaging materials for shipping that are supplied to
you.
guidelines" on page 30.
the bottom of the backplane cage.