IBM System x3530 M4 Installation And Service Manual page 184

Table 13. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
806f0513-2582xxxx A PCI SERR has
occurred on system
%1.(%1 =
CIM_ComputerSystem.
ElementName)
806f0813-2582xxxx An Uncorrectable
Bus Error has
occurred on system
%1.(%1 =
CIM_ComputerSystem.ElementName)
806f0125-0B01xxxx The entity of PCI
806f0125-0B02xxxx riser has been
detected absent for
PCI n. (n = PCI slot
number)
General messages
168
System x3530 M4 Type 7160: Installation and Service Guide
Error A PCI SERR has
occurred. (Sensor =
PCIs)
Error A bus
uncorrectable error
has occurred.
(Sensor = Critical
Int PCI)
Info The entity of PCI
riser n has been
detected absent. (n
= PCI slot number)
1. Check the PCI LED. See more
information about the PCI LED in
"Light path diagnostics LEDs" on
page 109.
2. Reseat the affected adapters and
riser card.
3. Update the server firmware (UEFI
and IMM) and adapter firmware.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code is
supported for the cluster solution
before you update the code.
4. Make sure that the adapter is
supported. For a list of supported
optional devices, see
http://www.ibm.com/systems/
info/x86servers/serverproven/
compat/us/.
5. Replace the adapters.
6. Replace the riser cards.
1. Check the system-event log.
2. Check the PCI LED. See more
information about the PCI LED in
"Light path diagnostics LEDs" on
page 109.
3. Remove the adapter from the
indicated PCI slot.
4. Check for a server firmware update.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code is
supported for the cluster solution
before you update the code.
5. (Trained technician only) Replace
the system board (see "Removing
the system board" on page 354 and
"Replacing the system board" on
page 359).
No action; information only.