Replacing A Raid Adapter Battery Remotely In The Server - IBM System x3530 M4 Installation And Service Manual

6. Lift the battery from the RAID battery tray.
7. Disconnect the remote battery cable from the remote battery cable connector to
the ServeRAID adapter.
If you are instructed to return the RAID adapter battery, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.

Replacing a RAID adapter battery remotely in the server

When you install any ServeRAID adapter in the server that come with a RAID
adapter battery, the battery must be installed remotely to prevent the battery from
overheating. The battery must be installed only in the RAID battery tray on top of
the power safety cover.
To install the RAID adapter battery in the RAID battery tray, complete the
following steps:
1. Read the safety information that begins on page Safety and "Installation
guidelines" on page 30.
2. Install the battery in the RAID battery tray:
a. Orient the battery as shown in the following illustration; then, lower the
battery into the RAID battery tray. If the battery comes with a battery
carrier, ensure that battery carrier posts align with the rings on the battery
mounting slot so that the battery carrier is secure in the slot.
Note: The positioning of the remote battery depends on the type of remote
battery that you install.
b. Rotate the retention clip to the close position and press down on the
retention clip until it snaps in place to hold the battery in place.
Chapter 6. Removing and replacing components
317