IBM System x3530 M4 Installation And Service Manual page 143

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
v Go to the IBM support website at http://www.ibm.com/supportportal/ to check for technical information, hints,
tips, and new device drivers or to submit a request for information.
Diagnostic
code Message
I.1800F [I.1800F] A processor family
mismatch has been detected for
one or more processor
packages.
I.18010 [I.18010] A processor stepping
mismatch has been detected for
one or more processor
packages.
Description
Processors have mismatched
Family.
Processors of the same model
have mismatched Stepping ID.
Action
1. Make sure that the microprocessor
is on the ServerProven website at
http://www.ibm.com/systems/
info/x86servers/serverproven/
compat/us/ .
2. Check the IBM support website
for an applicable retain tip or
firmware update that applies to
this problem.
3. (Trained technician only) Remove
and replace the affected
microprocessor (error LED is lit)
with a supported type (see
"Replacing a microprocessor and
heat sink" on page 349).
1. Make sure that the microprocessor
is on the ServerProven website at
http://www.ibm.com/systems/
info/x86servers/serverproven/
compat/us/ .
2. Check the IBM support website
for an applicable retain tip or
firmware update that applies to
this problem.
3. (Trained technician only) Remove
and replace the affected
microprocessor (error LED is lit)
with a supported type (see
"Replacing a microprocessor and
heat sink" on page 349).
Chapter 4. Troubleshooting
127