IBM System x3530 M4 Installation And Service Manual page 189

Table 13. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
806f000f-22010bxx Firmware BIOS
(ROM) corruption
was detected on
system
[ComputerSystemElementName]
during POST.
Error Firmware BIOS
(ROM) corruption
was detected
during POST.
(Sensor = ABR
Status)
1. Make sure the server meets the
minimum configuration to start
(see "Power-supply LEDs" on page
114).
2. Recover the server firmware from
the backup page:
a. Restart the server.
b. At the prompt, press F3 to
recover the firmware.
3. Update the server firmware to the
latest level (see "Updating the
firmware" on page 71).
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code is
supported for the cluster solution
before you update the code.
4. Remove components one at a time,
restarting the server each time, to
see if the problem goes away.
5. If the problem remains, (trained
technician) replace the system
board.
Chapter 4. Troubleshooting
173