IBM System x3530 M4 Installation And Service Manual page 54

To install a DIMM, complete the following steps:
1. Read the safety information that begins on page Safety and "Installation
2. Turn off the server (see "Turning off the server" on page 21) and all attached
3. Remove the top cover (see "Removing the server top cover" on page 362).
4. Open the retaining clip on each end of the DIMM connector.
38
System x3530 M4 Type 7160: Installation and Service Guide
guidelines" on page 30.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.